WAC Lighting QMP-G1RN Manuel d'utilisateur télécharger pdf

11/22/06 Rev 1

INSTRUCTIONS: Quick Connect Canopies

Models: QMP-M1RN and QMP-G1RN

CAUTION:

Read all instructions.

Do not conceal or extend exposed conductors through a building wall.

Do not install this system in wet locations.

For low voltage exposed insulated conductor systems required by 30.1© do not install any part of this

system less than 7 feet (2.2m) above the floor.

To reduce the risk of fire and burns, do not install this lighting system where the exposed bare conductors

can be shorted or contact any conductive materials.

To reduce the risk of fire and overheating, make sure all connections are tight.

Do not install any luminaire closer than 6 inches ( 15.25 cm) from any curtain, or similar combustible

materials.

Turn off electrical power before modifying the lighting system in any way.

SAVE THESE INSTRUCTIONS

Overview: Canopies are designed to fit all W.A.C

quick connect fixtures. They may also be used on

other manufacturers brand of quick connect

(consult factory for compatibility). Uses a 50 watt

max fixture or pendant.

Canopies come with a self-contained electronic

transformer that may be dimmed with an

electronic low volt dimmer switch.

1. Loosen the three canopy screws and

separate the canopy from the base plate.

2. Remove a knock out from the base plate.

3. Support canopy and guide the black and

white wires and from the transformer through

the knock out in the base plate and into the

Junction box.

4. Connect ground wire from junction box to the

green grounding wire from the base plate.

5. Connect corresponding line volt wires from

the junction box to transformer wires, with

wire nuts (supplied). Tuck excess wire into

the junction box.

6. Attach the base plate to the junction box

using the slotted holes.

7. Raise the canopy to the base plate, and

tighten the three screws loosened earlier.

Junction Box

Base Plate

Ground wire

Canopy

Quick Connect

fitting

Finishing ring

Shown with QF-194

Fixture (not included)

Résumé du contenu

Page 1 - Fixture (not included)

11/22/06 Rev 1 INSTRUCTIONS: Quick Connect Canopies Models: QMP-M1RN and QMP-G1RN CAUTION: Read all instructions. Do not conceal or extend

Commentaires sur ces manuels

Pas de commentaire

WAC Lighting QMP-G1RN Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Non WAC Lighting QMP-G1RN. WAC Lighting QMP-G1RN User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels